Support Hub/Troubleshooting/Fingerprint or Face Not Recognized: Causes and Fixes
Fix

Fingerprint or Face Not Recognized: Causes and Fixes

Most recognition problems come from the finger or face, the sensor, or a poor enrollment. These are general tips. Menus differ between models.

Find out how wide the problem is

  • One person fails: the cause is usually the enrollment or the finger or face. Go to the next sections.
  • Everyone fails: the cause is usually the sensor, the camera or the device. See "If everyone fails".

Fingerprint

  • Clean the sensor window with a soft, dry cloth.
  • Very dry, wet, dirty, worn or cut fingers read badly. Clean and dry the finger and try again.
  • Press the finger flat, centered on the sensor, with steady pressure.
  • Use the same finger that was enrolled.
  • Enroll again, and enroll two or more fingers for each person. Cams stores fingerprints in slots 0 to 9 for each user, as far as the model allows.

Face

  • Stand facing the camera at a normal distance, with the face fully visible.
  • Avoid strong light behind the person, and direct sun on the camera.
  • Clean the camera window.
  • If the person's look changed a lot, enroll the face again.

Enroll the user again

  1. Delete the user's fingerprint or face on the device, or delete the user.
  2. Add the user again, in a good environment, with the person present.
  3. Test the match at the device straight away.

Tip: a user can also be given a card or a password if your device supports it, as a backup way to punch.

If everyone fails

  • Clean the sensor or camera.
  • Restart the device.
  • Check that the model supports the method you are using. Support for fingerprint, face, palm, card and PIN depends on the device.
  • If it still fails, contact support. A damaged sensor needs service.

Still stuck? Email support@camsbiometrics.com with the device serial number and a short description of the problem.

Was this article helpful?